2025 Sea Fox 248 Side-Console powered by a Yamaha F300XSB
Sea Fox Boat Company was founded in 1995 by Freddy Renken, a 3rd generation boat manufacturer. In the past 27 years, Freddy and his team have worked hard to keep the family legacy alive with a primary focus on building the best quality boats at a fair price. Our goal at Sea Fox is to build boats with the fishing expert in mind while not sacrificing the comfort for friends and family.
With a combined 65 years of experience in providing customers access to leisure on the water, we aim to produce all the amenities you could possibly need so that you can leave your worries at the dock and escape like a fox.
- 12-volt power point
- 1100 GPH bilge pumps with built in electronic float switches (2)
- Aft bench seat with removeable cushions
- All around folding navigation-anchor light
- Anchor compartment with rope storage locker
- Casting deck with removable filler board
- Composite hull & deck
- Console berth
- Console courtesy lights
- Console dash shroud
- Console sink
- Cup holders (6)
- Curved bow backrest cushions
- Five Rod holders
- Forward console seating with contoured backrests
- For Yamaha digital motors (Multifunction instrumentation with tachometer, speedometer, volt, fuel, and fuel management functions)
- Freshwater pump
- Fresh water washdown outlet
- Full cockpit coaming pads
- Fusion Apollo Marine Stereo
- Fusion marine speakers
- Horn
- Illuminated switch panel
- Integrated console footrest
- Isothalic gelcoat
- Leaning post helm seating with backrest and hinged bolsters
- LED Navigation Lights
- LED spreader lights
- Limited Lifetime Hull Warranty
- Livewell light
- Livewell with window (40 gallons, 800 GPH aerator)
- Lockable console door
- Marine fuel/water separating filter
- Marine grade soft mat deck accents
- Marine grade soft mat decking and console accents
- Molded-in storage boxes
- Port side removable bow backrest
- Pre-rigging for two batteries
- Raw water pump
- Raw water washdown outlet
- Recessed electric trim tabs with integrated hull design
- Reinforced mounting pad for radar installation
- Removable bow filler cushion
- Removable table with leg
- Sand-grip deck surface
- Stainless steel bow eye with chafe plate
- Stainless steel closeout rings for rod holders
- Stainless steel compression latches
- Stainless steel fasteners
- Stainless steel pull-up cleats (6)
- Stainless steel rear boarding telescopic ladder with integrated boarding handle
- Stainless steel recessed grab rail at bow
- Stainless steel rod holders (4)
- Stainless steel steering wheel with turning knob
- Stainless steel table mount
- Stainless steel through bolted grab rail
- Stainless steel through hulls
- Stainless steel transom saver
- Stainless steel U-bolts on port and starboard transom
- Stainless steel walkthrough gate
- Top mount compass on console
- Two LED overhead lights (red, white, & blue power cycle)
- Under gunwale recessed rod storage
- Under seat insulated storage & fishbox
- Vinyl ester barrier coat
- White powder coat frame
- Windscreen
Centerline Length: 24'-4"
Beam: 8'-6"
Bridge Clearance: 99”
Deadrise: 18 degrees
Draft (hull): 14"
Transom: 25"
Dry Weight: 3,593 lbs
Maximum Weight: 5,925 lbs
Fuel Capacity: 117 gal
Persons Capacity: 10
Total Capacity: 2,500 lb
Maximum Horsepower: 300 hp
Browse through the vast selection of boats that have recently been added to our inventory.
